Part 8

II.—EVAPORATION.

Solar heat rarefies the air by driving its particles asunder; it also vaporises water from the surface of river, lake, and ocean, diffusing the vapour through the atmosphere.

Great interest attaches to the subject of Evaporation, on account of its connection with rainfall and water supply. It is to be regretted, therefore, that the results hitherto obtained in the endeavour to measure its rate and quantity do not merit much confidence as regards their applicability to the evaporation occurring in nature, owing to the exceptional manner in which the observations have been made.

There is this uncertainty about evaporation, that all the experiments relate to that taking place from an exposed water surface of a, comparatively speaking, infinitesimally small area, and can therefore have but a very partial applicability to the conditions occurring in nature. There are two main reasons for this statement. Firstly, the proportion of the surface of the land on the earth which is covered with lakes and rivers is very limited, and the experiments above indicated throw no light on the evaporation from the soil. Secondly, the evaporation from the surface of a small atmometer erected on the ground, with comparatively dry air all around it, is certainly very different from that which would take place from an equal area in the centre of a large water surface, such as a lake.

It is of course easy to make experiments on the evaporation from the soil by means of a balance atmometer, but in order that these should possess a practical value, the investigation must be extended so as to include a wide variety of soils, &c., &c. As regards the second point which has been raised, it is recommended by the Vienna Congress to erect atmometers in the centre of water surfaces; but it is not a very easy matter to conduct such experiments with accuracy, owing to the risk of in-splashing from waves.

BABINGTON’S ATMIDOMETER measures evaporation from water, ice, or snow, and in form resembles a hydrometer, with the difference that the stem bears a scale graduated to grains and half grains, and is surmounted by a light, shallow copper pan. When in use, the hydrometer-like instrument is immersed in a glass vessel having a hole in the cover, through which the stem protrudes. The copper pan is then placed on the top, and sufficient water, ice, or snow placed therein to sink the stem to the zero of the scale. As the evaporation proceeds, the stem rises; and, if the time of commencing the experiment is noted, the rate as well as the amount of evaporation is indicated in grains.

III.—RAREFACTION.

The diffusion of aqueous vapour through the air and the rarefying influence of heat jointly effect an alteration in the weight of the atmosphere. This alteration of weight is determined by the Barometer, an instrument invented by TORRICELLI, in 1643, and in so perfect a form that in its essential features it has not been superseded.

The mode of construction is illustrated by Figs. 21 and 22. It consists in hermetically sealing a glass tube about three feet long and filling it with mercury. The finger is placed over the open end of the tube, which is then inverted and placed in a cistern of mercury and the finger withdrawn. The left-hand figure shows the result; the mercury is seen to fall some three or four inches, leaving an empty space at the top of the tube, which is called the “Torricellian vacuum.”

The mercury is prevented from falling lower than is shown, by the external pressure of the atmosphere on the cistern. The weight of this column, therefore, represents the weight or pressure of a corresponding column of air many miles in height; and so close is the relation between the column of mercury and the external air that the height of the former changes with the slightest variation in the weight of the latter, and the instrument thus becomes a measure of the weight of the air, from which property its name is derived, the Greek words baros and metron signifying respectively “weight” and “measure.”

When the mercury in the barometer tube falls, that in the cistern rises in corresponding proportion, and vice versa, so that there is an ever-varying relation between the level of the mercury in the tube and the mercury in the cistern, which affects the accuracy of the readings. In M. Fortin’s cistern this difficulty is obviated by the use of a glass, with flexible leather bottom and a brass adjusting screw, as shown in the cut. Through the top of the cistern is inserted a small ivory point, the lower end of which corresponds with the zero of the scale; and, to secure uniformity, the level of the mercury in the cistern should be adjusted by the screw at each observation, until the ivory point appears to touch its own reflection on the surface. The reading is then taken.

In making barometric observations for comparison with others, it is necessary that all should be reduced to the common temperature of 32° F., and for this purpose tables have been calculated which will be found to save much time.

Tables also for reducing observations of the barometer to sea level, an operation equally indispensable with the other corrections to make the readings intercomparable, have been published by direction of the Meteorological Committee.

For the British Isles the mean sea-level at Liverpool has been selected by the Ordnance Survey as their datum, and the height of any station may be ascertained by first noting the nearest Ordnance Bench Mark thus ↑, and purchasing that portion of the Ordnance map which includes the station, near to which the Bench Mark will be found with the height above sea-level duly entered. The levellings made for railways will also furnish the desired information. Failing both these, the observer should select two or more of the stations nearest his locality for which official Meteorological Reports are published daily in the Times and other journals; and taking observations of his barometer at 8 a.m., for a few weeks, should compare them with the mean of the observations at those stations. The comparison should be omitted when the barometer pressure is not steady.

A Standard Barometer is constructed on FORTIN’S principle, and should have its tube about half an inch bore, enclosed in a brass body having at its upper end two vertical openings, in which the vernier works. The mercury is seen through these openings, aided by light reflected from a white opaque glass reflector let into the mahogany board behind. The scale is divided on one side into English inches and 20ths, and may have on the other French millimetres, the vernier enabling a reading to be taken, in each case respectively, of 1/500th of an inch and 1/10th of a millimetre. In making the instrument, the mercury is boiled in the tube, to ensure the complete exclusion of air and moisture; while FORTIN’S principle of cistern ensures a constant level from whence to take the readings. A sensitive thermometer with scale, engine-divided on stem, is attached to the brass mount, which is perforated to admit the attenuated bulb of the thermometer into absolute contact with the glass tube of the barometer, to ensure its indicating the same temperature as the contained mercury. The instrument is suspended by a ring from a brass bracket attached to a mahogany board, and the lower end passes through a larger ring having three screws for adjusting it vertically.

A “reading” is taken in the following manner:—1. Note the temperature by the attached thermometer. 2. Raise or lower the mercury in the cistern by turning the screw underneath until the reflected image of the ivory point on the mercury seems to be in contact with the ivory itself. By the milled head at the side, the vernier is adjusted until its lower edge just touches the top of the mercurial column, the scale and vernier then indicate the height of the barometer in inches, 10ths, 100ths, and 1000ths.

High-class instruments, such as that here described, yield exact readings; but, in order to note them accurately, it is important that the eye, the zero edge of the vernier, the top of the mercurial column, and the back of the vernier should be in the same horizontal plane; conditions which may be obtained after some practice.

The accompanying illustration shows a form of barometer which, though not much used in this country, is deservedly popular on the Continent as a standard station barometer. It is called a Syphon Barometer, and was designed by Gay-Lussac. The open end of the tube is bent up in the form of a syphon, the short limb being from six to eight inches long; it is furnished with metal scales and verniers, and is mounted on a mahogany board with attached thermometer.

These barometers require no correction for capillarity or capacity, each surface of mercury being equally depressed by capillary attraction, and the quantity of mercury falling from the long limb occupies the same space in the short limb. The usual correction for temperature must, however, be applied. A scale of inches, measured from a zero point taken near the bend of the tube, furnishes the means of measuring the long and short columns. The difference of readings is the height of the barometer.

The VERNIER is a movable scale for subdividing parts of a fixed scale, and was first applied to that purpose by its inventor, M. PIERRE VERNIER, in 1630. In the barometer the parts to be divided are inches, which by the aid of this invention are subdivided into 10ths, 100ths, and 1000ths.

Fig. 27 shows the scale of a standard barometer divided into 1/2-10ths, or ·05 of an inch. The Vernier C D is made equal to 24 of such divisions, and is divided into 25 equal parts, from whence it follows that one division on the scale is 1/25th of ·05 larger than one on the vernier, so that it shows a difference of ·002 of an inch. The vernier reads ·0, or zero, upwards; D, therefore, indicates the top of the mercurial column.

In Fig. 27, zero on the vernier is exactly in line with 29 inches and 5/10ths of the fixed scale; the reading, therefore, is 29·500 inches. The vernier line a falls short of a division of the scale by ·002-inch; b, by ·004; c, by ·006; d, by ·008; and the succeeding line by ·010. If the vernier be adjusted to make a coincide with z on the scale, it will have moved through ·002-inch; and if 1 on the vernier be moved to coincide with y on the scale, the space measured will be ·010-inch. Consequently, the figures 1, 2, 3, 4, 5, on the vernier, measure 100ths, and the intermediate lines even 1000ths of an inch. In Fig. 28 the zero of the vernier is between 29·65 and 29·70 on the scale. Glancing up the vernier and scale, the second line above 3 will be found in a direct line with one on the scale; this gives ·03 and ·004 to add to 29·65, so that the actual reading is 29·684. In those instances where no line on the vernier is found precisely to coincide with a line on the scale, and doubt arises as to which to select from two equally coincident lines, the rule is to take the intermediate 1000th of an inch.

For household and marine barometers such minute subdivisions of the scale are unnecessary, and the scales of such instruments are therefore divided only to 10ths, and the verniers made only to read to 100ths of an inch, which is effected by making the vernier 9/10ths or 11/10ths of an inch long, and dividing it into 10 equal parts.

In “taking a reading” it is important that it should be done as quickly as possible, as the heat from the body and the hand is sufficient to interfere with that accuracy which is necessary where the intention is to compare the readings with those made by other observers. This facility is soon acquired by a little practice.

Pediment Household Barometers, though not so imposing in appearance as the Wheel Barometer, yield direct readings without the intervention of the mechanical appliances necessary for moving a needle over an extended dial. Their mountings are for the most part in oak, walnut, and other woods, the scales are of ivory, porcelain, or enamelled glass, and in their graduation due regard is paid to the relative proportions of cistern and tube, so that the conditions essential to the production of a Standard Barometer are very closely attained. In common with other barometers, it should hang in the shade in a vertical position, so that light may be seen through the tube. As a purchaser would receive it in what is called a “portable” state, it will be necessary on first suspending it to take the pinion key, fit it on the square-headed pin at the bottom of the instrument, and turn gently to the left till the screw stops. The effect of this is to lower the base of the cistern, and allow the mercury in the tube to fall to its proper level. The key should then be replaced for use in moving the vernier. To make this kind of Barometer portable for travelling it should be unhung, very gradually sloped until the mercury is at the top of the tube, when, the instrument being upside down, the base of the cistern is screwed up by turning the pinion key gently to the right until it stops. Care should be taken to avoid concussion, and to have the cistern end always uppermost, or the instrument lying flat.

Fig. 29 shows a useful form of barometer for the farmer, combining as it does three instruments in one, for the thermometer on the right hand of the scale having its bulb covered with muslin kept moist by communication with a cistern of water enables the two thermometers to be employed as a Hygrometer, the use of which is described at page 50. This barometer should be suspended in a place where it will be exposed as much as possible to the external air, but not in sunshine.

In Wheel Barometers the varying height of a column of mercury is shown by the movement of a needle on a divided circular dial, by adopting the syphon form of barometer tube, concealed behind the dial and frame. An iron or glass float sustained by the mercury in the open branch (Fig. 31) is suspended by a counterbalance a little lighter than itself. The axis of the pulley has the needle attached to it, and consequently moves the needle with the rise and fall of the mercury. It is obvious, therefore, that if the atmospheric pressure increases the float falls and the needle turns to the right, and if it diminishes the needle turns in the opposite direction. The divisions on the scale represent inches, tenths, and hundredths in the rise and fall of a column of mercury, and these can be read with great facility, as one inch occupies the space of six or more on this very open scale, according to size of dial (Fig. 30). The wording is arbitrary, and indicates the probable weather that may be expected.

Important improvements have recently been effected in this form of household barometers, so that they may be recommended as good weather indicators where facility of reading is a desideratum.