The Geologic Story of Yellowstone National Park

Section C-C′). Movement Along One Reverse Fault in This Area Was Locally

more than 10,000 feet.

As the lands were uplifted and contorted, they came under vigorous attack by the ever-present agents of erosion. Tremendous quantities of rock were stripped from the highlands, and the debris was carried by streams into the adjacent lowland basins and deposited mostly as sand and gravel. As the highlands continued to rise, the basins continued to sink, and in a short period of time great thicknesses of basin-fill sediments accumulated locally. One such deposit, the Harebell Formation of latest Cretaceous age in south-central Yellowstone (fig. 5), is more than 8,000 feet thick.

Other similar anticlines, synclines, and reverse faults no doubt extend far into the interior of Yellowstone National Park, and perhaps entirely across it in places, but they lie buried beneath a thick capping of volcanic rocks. Nevertheless, it seems safe to conclude that none of the Park area escaped the effects of the great forces of the Laramide orogeny. These forces, regardless of how they originated deep within the earth, seem to have been compressional (fig. 13), pushing the upper layers of the earth’s crust from the east and northeast toward the west and southwest. This interpretation is based on the style of the structural features just described, which shows that the steep limbs of folds, as well as the direction of movements along reverse faults, point toward the west or southwest (fig. 14).

By early Eocene time, about 20 million years after they had begun, the deformational forces relaxed. But the effects of the giant earth movements were to last for a very long time. Crustal disturbances of such magnitude commonly produce conditions deep within the earth which, in places, gives rise to intense volcanic activity; one such place was Yellowstone.

Volcanic activity

In early Eocene time, between 55 and 50 million years ago, several large volcanoes erupted in and near Yellowstone National Park. This volcanic activity resulted in the accumulation of the vast pile of Absaroka volcanic rocks (fig. 5) which now makes up most of the Absaroka and Washburn Ranges and part of the Gallatin Range, and which covers several other smaller areas in the Park (pl. 1).

What special geologic conditions would cause these spectacular eruptions of molten rock at the earth’s surface? Measurements taken in deep mines and oil wells show that the normal increase in the earth’s temperature with depth is about 1°F per 100 feet. This heat is generated by the decay of radioactive elements—chiefly uranium, thorium, and potassium—which are present in at least small amounts in virtually all rocks of the earth’s crust. Ordinarily, enough heat is conducted to the earth’s surface so that the deeply buried rocks do not become hot enough to melt. In some places, however, the heat is not carried off fast enough, and the temperature rises slowly toward the melting point of the rock. Such hot spots may develop (1) because the rocks in those places contain more than an average amount of radioactive elements; (2) because hotter material moves upward from still deeper levels in the earth; or (3) because drastic changes in pressure are brought about by the alternate squeezing and relaxing of mountain-building forces, which in turn substantially affect the melting point of the rocks. Whatever the cause, the eventual result is the accumulation of a huge body of molten rock, called magma, enclosed in a deep underground chamber.

Magma, being a mixture of hot liquids and gases that is lighter in weight than the solid rocks surrounding it, tends to rise toward the earth’s surface. Forcing its way upward, some of the molten material solidifies before reaching the surface and forms bodies of various kinds of intrusive igneous rocks (fig. 15). Some of the magma, however, reaches the surface and either pours out as lava or is blown out explosively as rock fragments, ash, and pumice to form extrusive igneous rocks.

Rock name Principal rock-forming Color minerals

Rhyolite Quartz, feldspar Light to medium shades of gray (sanidine). and brown. Andesite Feldspar Medium to fairly dark shades of (plagioclase), brown, red, purple, and gray. pyroxene (augite). Basalt Feldspar (plagioclase), Nearly black. pyroxene, olivine, magnetite.

Clear to light-colored silicon dioxide.

Light-colored aluminum silicate minerals.

Dark-colored iron and magnesium silicate minerals.

Very dark colored iron oxide mineral.

The magmas which formed the Absaroka volcanoes erupted mainly through large central vents (fig. 16). Most of the eruptions were fairly quiet, with the molten rock welling up to the surface and cascading down the sides of the volcanoes chiefly as viscous lava flows and breccias. Rain, seeping into these porous rocks, caused huge landslides of mud and broken rock to stream down the mountainsides. Hence, many of the rocks seen today are volcanic breccias—jumbled but crudely layered deposits of large and small angular blocks embedded in a sandy matrix, much like man-made concrete except that the rock fragments are considerably coarser (fig. 17). Viewed from a distance, however, most of the breccia deposits have a distinct layered appearance (fig. 18). The predominant extrusive igneous rock in the Absaroka volcanic sequence is andesite, but basalt also occurs in places (fig. 15).

Chiefly lava flows of shield volcano Chiefly volcanic sandstone and conglomerate of lowland areas Chiefly volcanic breccias and thin lava flows of cone-type volcano

At times the Absaroka volcanic eruptions were violently explosive, showering the countryside with rock bombs, cinders, and ash. The finer debris that reached the lower slopes of the volcanoes was reworked and carried by streams into the intervening valleys, where it was deposited as sand and gravel (fig. 16). Eventually the entire Yellowstone region was choked with volcanic debris, the material from one volcano mixing with that from neighboring volcanoes. Even the mountain masses uplifted during the preceding Laramide orogeny were covered by the vast accumulation (fig. 18).

Absaroka volcanism, however, was not a simple, continuous process—the eruptions were intermittent, the many volcanoes were not always active at the same time, and between eruptions there were long periods of quiescence during which the erupted material was deeply eroded. The repetitive nature of the eruptions is best illustrated by the famous fossil forests of Yellowstone. Here is striking evidence that enough time elapsed between eruptions for widespread forests to become established on the lower slopes of the volcanoes and in the broad valleys between them. Judged from the great size of some of the now-petrified logs (fig. 19), several hundreds of years must have passed before another volcanic outburst smothered the forest. Many different forest layers have been recognized in the Specimen Ridge area as well as in several other places throughout the Park.

As the Absaroka magma rose from deep underground, some of it squirted, like toothpaste, into the layered Paleozoic and Mesozoic sedimentary rocks through which it passed. These relatively small masses of molten rock material slowly cooled and crystallized to form intrusive igneous rocks such as diorite (fig. 20). The resulting intrusive bodies, called sills, dikes, stocks, and laccoliths, depending on their form, are most abundant in the Gallatin Range and in the vicinity of the East Entrance (pl. 1). At the conclusion of volcanic activity, the last of the rising magma solidified in the main conduits to form slender, somewhat cylindrical bodies of rock called volcanic necks that probably conform closely to the shape of the original conduits. The circular intrusive rock body at Bunsen Peak (fig. 21), now exposed to view because erosion has stripped away the lava and volcanic breccia that once completely buried it, represents either a volcanic neck or a small stock that solidified directly beneath a volcano.

Mount Washburn is the north half of one of the ancient Absaroka volcanoes (fig. 26), and many of the rocks and other features related to this volcano, which characterized this great period of volcanism, can be seen along the road between Canyon Village and Tower. In roadcuts just south of Dunraven Pass several thin igneous dikes cut through volcanic breccias. These dikes radiate outward from the nearby central core of the volcano, which lies east of the highway in the vicinity of Washburn Hot Springs. From Dunraven Pass northward for 2-3 miles, the road is lined with lava flows and very coarse breccias that accumulated close to the volcanic neck (fig. 17). Farther north toward Tower Falls, breccias and conglomerates predominate, but the average size of individual rock fragments decreases gradually northward away from the center of eruption. Beds of sandstone then begin to appear in the sequence, having been deposited mainly by streams that drained the north slope of the volcano.

At the end of Absaroka volcanism, approximately 40 million years ago (fig. 6), all of Yellowstone lay buried beneath several thousand feet of lavas, breccias, and ash (fig. 18). The landscape must have appeared as a gently rolling plateau, drained by sluggish, meandering streams and dotted here and there by volcanoes still rising above the general level of the ground. This plateau surface, however, probably stood at a maximum of only a few thousand feet above sea level, for animals and plants now found as fossils in the Absaroka volcanic rocks indicate that warm-temperature to even subtropical climates existed during the volcanic period (fig. 19).

Continue reading The Geologic Story of Yellowstone National Park free in the Wunder reader →