Part 25

Why Does Iron Sink In Water?

The explanation in regard to the piece of wood floating in water is the beginning of the answer to this question. A piece of iron is heavier than an equal bulk of water, and will therefore go to the bottom, as will all things which are more dense than water. A piece of iron has no air in it. The particles of a piece of iron are so close together that there is no room for air in it and it will therefore sink in water. A piece of wood from which all of the air had been expelled would also sink.

Why Doesn’t an Iron Ship Sink?

This is a very natural question for you to ask right after you were told why iron sinks in water. The explanation is that by making an iron ship in the way we do, we fix it so that it holds a lot of air in between the bottom and sides, making the combination of the two--the iron ship and the air in it--lighter than the water on which it sails. Men thought at one time that a ship would sink if made of iron, and therefore built all of their ships of wood. Finally one inventor made a ship of iron and it was one of the wonders of the world. When we found that iron ships would float if they were built to retain sufficient air to keep them from sinking, we made the hulls of most ships of iron for a time. Now, however, the best ships are made of steel, which is even better.

If you bore a hole in the bottom of a ship, the water will run in if the ship is in the water, and the ship will sink, because the water coming in drives out the air; and when the ship is full of water, the water in it, with the ship itself, are heavier than the water on which it sails, and the ship will go down. Filling a ship with water makes the iron part of the ship just like a bar of iron, so far as its sinking qualities are concerned.

Of course, an iron ship must be made long enough and broad enough so that when it is completed there will be sufficient air contained within the hull to make the combination lighter than water. Always, therefore, when a ship is to be built, competent engineers must go over the plans of the vessel and calculate the air capacity, so as to make sure she will float.

Nowadays it would be difficult to sink a modern vessel by boring one small hole in the bottom, because the bottom and sides are lined with enclosed steel air-chambers, and a ship will keep afloat even if one or a number of holes are made. The reason is, of course, that when you bore a hole into one of these air-chambers the water rushing in will fill that air-chamber with water, but as there is no connection from the inside with the rest of the ship, the water can get no further.

Why Does a Poker Get Hot at Both Ends if Left in the Fire?

Both ends of the poker become heated because the poker is made of iron, and iron is a particularly good conductor of heat. To understand this we must look into the question of what a good conductor of heat is. In this case the particles of iron, which combined form the poker, are so close together that when those at the end of the poker which is in the fire get hot, the particles at that end hand the heat on to the particles next to them, and so on until the whole poker is hot. The difference between a thing which is a good conductor of heat and a thing which is not a good conductor, lies in the ability of the different particles which compose it to hand the heat on to the others. Did you ever notice that the handle of a solid silver spoon will become hot if the spoon is left in hot coffee? Solid silver is a good conductor of heat. A plated spoon is not a good conductor, however, and will not become hot if left in the cup of hot coffee as a solid silver spoon will.

Would a Wooden Spoon Get Hot?

A wooden spoon would not get hot, because wood is not a good conductor of heat. The atoms which compose the wood have not the power to transmit the heat to each other. This is strange, too, when we think that a poker is a good conductor of heat, but will not burn, while wood is not a good conductor, but will burn readily. Perhaps you have already discovered this in connection with a wood fire. One end of a stick of wood may be burning fiercely, and yet you can pick it up by the other end and find it is not even warm. This proves to you that wood is not a good conductor of heat, and explains why the handle of a wooden spoon in a bowl of hot soup will not get hot while the handle of a silver spoon will.

Why Does Iron Turn Red When Red Hot?

The answer is that the piece of iron has been heated to the point where it gives off light of its own. The red you see is only one stage in the development of iron to the point where it makes its own light. If you heat it still more it will make a white light. You know that it produces the light itself, because if you take a piece of iron into a perfectly dark room and heat it to a white heat it will show better than where there is other light. If you continue the process the iron will melt and change in form. Therefore, the “red hot” name for a piece of iron in that state is a perfect name. It is a warning that the iron is coming to a point where if the heating process is continued, it will change its form and in this state, when treated according to known methods, the iron is turned into steel, which has many characteristics that iron does not possess. Now, I can, of course, hear you ask why doesn’t an iron kettle get red hot? and I can answer that easily. If you treat the kettle the same way as you do the piece of iron, it will get red hot. The difference is that you are thinking of an iron kettle with water in it. As long as there is any water in the kettle, that keeps it from getting hot. The water inside keeps the kettle from becoming red hot. If you took a hollow rod of iron and filled it with water, it would not become red hot as long as any water remained in the hollow portion.

How Did the Sand Get on the Seashore?

The sand on the seashore is nothing more or less than ground-up sandstone. In dealing with the inanimate things in the world we find that a very important element of all of them has been given the name silicon. When the crust of the earth, which is the part we call the land and rocks, and includes the part under the sea, was a molten mass, this silicon was burned, combining with the oxygen which surrounded everything, and produced what is known as silica. Silica is the name given to the thing which is left after you burn silicon. A very large part of this silica was deposited in parts of the earth, and when the crust of the earth cooled off it was sand. By pressure and contact with other substances it became stuck together, just as you can take wet sand at the seashore to-day and make bricks and houses and tunnels, excepting that in the case we speak of it was something besides water that pressed and stuck the little particles of sand together. They stuck together more permanently. Then when the oceans were formed, as shown in another part of this book, much of the sandstone was found to be at the bottom and on the shores of the oceans. The action of the water continually washing against the sandstone gradually broke the sandstone up into the tiny particles of sand again, and this is what makes the sand on the seashore.

What Makes a Soap Bubble?

A bubble is merely a hollow ball of water with air inside. The air in coming up through the water in trying to rise out of the water is caught in the water in such a way as to form the bubble, and since the ability of the air inside of the bubble to rise is greater than that of the water which forms the bubble, and which has a tendency to pull it down, the bubble rises into the air. The water ball is very thin and keeps running down to the bottom of the ball, where you see it form into drops, and soon this makes the walls of the water bubble so thin that the air bursts through the ball of water, and that is

What Makes the Bubble Explode?

Sometimes we blow soap bubbles. We mix soap in the water and that makes the walls of the water ball which we produce a little tougher, and it requires a great deal more effort for the air to escape from it, as the soap keeps the water in the walls of the bubble from running down to the bottom for quite some time, and, therefore, soap bubbles will often travel in the air for some distance. The colors we see on soap bubbles are produced by the rays of sunlight, which strike the bubble and reflect them back to us in colors very similar to those of the rainbow.

Why Are Bubbles Round?

Bubbles are round because the air which forms the inside of the bubble exerts an equal pressure in all directions. It presses equally against all sides of the bubble at the same time.

The Story in a Yard of Silk

God’s Creation and Man’s Invention.

~WHERE DOES SILK COME FROM?~

Silk in its finished state is an ideal product. It is at once durable, magnificent to the eye, tender to the touch, and its rustle is soft music to the ear. Hence it is easy to understand why the silkworm, from the earliest times, has been an object of much consideration and concern from a commercial and industrial point of view. In this country alone, we annually expend as much for silk goods as we do for public education and thirty times as much as we do for foreign missions. Such an indomitable producer of wealth is the silkworm, and a producer of wealth it has been from an age as remote as when Joseph was down in old Egypt, interpreting the dreams of King Pharaoh’s butler and baker and later that of the King himself.

To-day we speak of twenty centuries, and our minds can hardly comprehend such a lapse of time. What shall we think of the silkworm, that for twice twenty centuries has furnished practically all the raw material for the world’s silk supply? Because man’s ingenuity is at present actively engaged in the attempt to displace it by cheaper substitutes, the thought has come to us that, without going too minutely into mechanical processes, a good opportunity is presented to give some interesting information in regard to the silkworm as the creation of the Divine Hand, in contrast to the silkworm as the creation of man.

According to Chinese authority, the use of silk dates from 2650 B.C., and it is generally conceded that, in point of age, it stands midway among the great textiles, wool and cotton having preceded it, while flax, hemp and other fibrous plants followed shortly in its train.

The first patron of the silkworm was Hoang-Ti, Third Emperor of China, and his Empress, Si-Ling-Chi, was the first practical silkworm breeder and silk reeler. It is related of her that she was once walking in the palace gardens when she discovered a strange and repulsive looking worm. It was small, of a pale green color, and was feeding greedily on a mulberry leaf. She interested the Emperor in this strange creature, and, at the Emperor’s suggestion, took the fine silken web which the worm finally spun, and was the first to successfully reel the new filament and weave it into cloth. So beneficial to the nation was her work considered that her gratified subjects bestowed upon her the divine title of “Goddess of the Silkworms,” and to this day the Chinese celebrate in her honor the “Con-Con Feast,” which takes place during the season in which the silkworm eggs are hatched.