Part 18

Making Contact

Palpate with left hand if standing on patient’s left to adjust a right, anterior subluxation. Find the offending anterior transverse, draw tissues away with middle finger of palpating hand, change to middle finger of free hand which marks and holds the point of contact. Now place (with care) the base of the little finger of the hand which was used for palpating, at a point just below the condyle of the last metacarpal and a little to the palmar side, in direct contact with the front of the transverse. The last finger will be flexed toward the radial side and a shallow depression thus left for the contact.

Completing Position

Hold contact lightly and slip the free hand under the patient’s head, which faces slightly toward the adjuster. Raise the head, bending the neck away from the adjusting hand and toward patient’s chest until it is felt that the contact is secure and that further movement would put the neck upon a strain. You are ready for

The Movement

which is delivered entirely with contact hand, downward and toward the back of the neck. The delivery is difficult because the force arm is flexed at the elbow and the position awkward. Practice, however, will soon render one adept.

Uses

For rotated vertebrae which have one transverse anterior to the other, Cervicals only. This move gives a slightly less advantageous force angle than the preceding, but is less likely to be painful.

SECOND METACARPAL CONTACT

Position of Patient

Place patient supine on bench so that his head extends beyond the end of bench and is supported by the upraised knee of the palpater. Stand at head of bench so as to face patient’s feet.

Use of Hands

Differing from their use in the preceding moves the hands are so placed that the adjusting hand for a right, anterior subluxation will be right hand, for a left anterior the left hand. The opposite hand supports the head after contact is made.

Making Contact

Contact point on hand is second metacarpal at the end of the condyle, or second metacarpo-phalangeal joint. This is placed in front of the offending transverse, the head having been rotated away from that side and other tissues drawn carefully aside from the bone. The back of the hand is downward toward the clavicle, fingers semi-flexed on palm, thumb resting on jaw.

Supporting Head

The following position is the correct one for supporting the head in all Cervical adjustments delivered in the above position of patient and adjuster.

Cup the supporting hand slightly and fit the patient’s ear into the cupped palm. Let fingers extend toward the base and back of the neck, the finger position varying according to the amount of rotation of the head so that the fingers are in all cases directly under the head weight. The wrist then flexes on the hand, and wrist and forearm are brought up across the patient’s forehead so that a force delivered from the opposite side cannot cause the head to roll or move upon the supporting hand. After placing both hands draw the head so that the chin is tilted upward until it is felt that contact is snug and tight. This supporting position is invaluable and much neglected by adjusters, who might save themselves much annoyance and many failures by its constant use. In the study of succeeding Cervical moves refer to this description frequently. We shall call it the Hook Support, because the arm and hand resemble a hook which grasps the under side of the head and curves over the upper.

Movement

This is delivered entirely with contact hand and in a direction as much posterior as can be achieved without slipping past the end of the process. If the head is sufficiently rotated away from the contact side the angle of force is better than with a straight lateral adjustment, which it somewhat resembles, but not so good for anteriors as either of the two preceding moves. It is chiefly useful when the other two fail.

OCCIPITO--ATLANTAL MOVE

To move an Atlas so disposed that its one side is posterior while the whole vertebra is laterally displaced in the same direction; to move, for instance, an Atlas R. P.

Have patient lying on back in position C with head projecting beyond bench and supported by adjuster’s knee.

Placing of Hands

Place the first three fingers of one hand under the most laterally prominent transverse so as to hold it firm, first placing the first finger carefully just behind and against the end of that transverse and then reinforcing it with the second and third fingers, slightly tensed, and resting their tips on the lamina close underneath the occipital bone.

Next place the other hand so that the thumb rests firmly upon the patient’s jaw and the first finger extends backward along the lower margin of the occipital bone.

To complete the position rotate the head gently toward the side of the laterally prominent Atlas, until it rests, face toward the side, and is supported by the three fingers of the one hand and the heel and wrist of the same hand. It will be noted that when the head is rotated the first finger of supporting hand slips to a position directly upon the tip of the transverse process and the other two take its place against the posterior aspect of the tip of the transverse. The Atlas now rests with its intertransverse line almost vertically upward from supporting fingers, which hold it against further rotation.

Movement