Part 6

=Send orders to

BATTERY APPLIANCE DIVISION

AMERICAN BUREAU OF ENGINEERING, INC. 2632 Prairie Avenue Chicago, Ill.=

PRICES SUBJECT TO CHANGE WITHOUT NOTICE

* * * * *

AMBU PRODUCTS that MAKE MONEY and SAVE TIME FOR BATTERY REPAIR SHOPS

* * * * *

AMBU Battery Steamers

Softens sealing compound on batteries. Within less than five minutes prepares them so that elements can be easily removed.

Automatic valve regulates water supply. Steam is quickly produced. Saves time and fuel cost.

For use with gas, gasoline, kerosene or electric stoves. Has six outlets and adjustable valve for opening the required number of outlets.

For Battery Men desiring to steam one or more batteries at one time, depending upon their size, we offer the Type “A” Steamer with Steaming Box.

AMBU CONDENSER FOR DISTILLING WATER, accompanies either type Steamer, if desired. When Steamer is not being used for steaming batteries, and when used in conjunction with this Condenser, will produce about one gallon of distilled water per hour at very small cost.

Type “B” Ambu Steamer complete with Condenser Type “B” Ambu Steamer without Condenser Prices Type “A” Ambu Steamer complete with Condenser on Type “A” Ambu Steamer without Condenser request Ambu Condenser for Distilling Water

* * * * *

AMBU Battery Plate Press

Three Groups of Plates Pressed at One Time

With the Ambu Plate Press there is no possibility of iron, the greatest enemy of a battery, touching the plates.

In discharged negative plates, the active material is bulged out and must be pressed back flush with the grids before the plates can be used again.

The Ambu Battery Plate Press is made of heavy hardwood timber with two horizontal wooden jaws between which the battery plates are pressed. A set of lead covered troughs carries away the acid. The upper jaw of the press is attached to a screw shaft for raising or lowering it. A complete set of transite boards for placing between the plates, and a substantial wall support are included in the purchase price. Press complete, including set of press separator boards sufficient to press three groups, and substantial wall support. Price on request.

Ambu Press Separator Boards in sets as above also may be purchased separately. Price on request.

* * * * *

AMBU Compound and Lead Ladle

A ladle that will permit of pouring sealing compound into the small openings between top covers or jars without spilling or slopping over top of battery. With the special center drain controlled by taper pin with touch of your thumb you are able to control the flow of sealing compound from the stream as fine as a pin to a stream as thick as your thumb.

Designed also for pouring lead, and has many advantages over ordinary ladle.

Made of forged malleable iron, extra deep, with two lips in addition to center spout, four inches in diameter. Price on request.

* * * * *

AMBU PRODUCTS that MAKE MONEY and SAVE TIME FOR BATTERY REPAIR SHOPS